NEW: waveform voltage amplifier & SIGNAL GENERATOR SOFTWARE 

NEW: SIGNAL GENERATOR waveform AMPLIFIER - SGVA-201

amplify your signal generator or analog output AO cards. higher current and up to 20 or 40 volts output
Signal generator waveform amplifier front view
signal generator voltage and current amplifier enables direct drive for servo motors and systems. Has over voltage and over heating protection built in
Signal generator waveform amplifier rear view
NEW: The signal generator waveform amplifier, takes the output from any signal or function generator and amplifies it to +-20V output with a direct current drive capacity of 400Ma. This is enough to drive most servo systems directly. 
  • Amplifies standard +-10V outputs to +-20V (40V Pk/Pk)
  • High current drive capability up to 400Ma
  • Current monitoring output (1Volt/100Ma)
  • Up to 400KHz bandwidth
  • Compatible with most function and signal generators
  • Compatible with NI Analog output or multifunction DAQ boards
  • Over temperature warning with output cut off feature

NEW: additional signal generator software functionality

The XY Signal Generator software (XYSG) is designed to work alongside the XY plotter software. It can be used to generate stimulus signals for you test requirement. The new XYSG software is compatible with the National Instruments range of analog output boards and multifunction DAQ boards (including cDAQ). You can use the standard XY plotter software to plot and store your test results. Uses include:
  • Frequency response
  • Hysteresis testing
  • Direct servo control